• ST-LINK (V1) boards are not supported on the Linux® and macOS® operating systems. Only ST-LINK/V2, ST-LINK/V2-1, and STLINK-V3 boards can be updated from these operating systems. • Applications programmed through...
I'm working on an STM32 MCU device with an on-board ST-Link v1.x debugger. After upgrading to Keil MDK 5.29, I can neither program the flash nor start a debug session, in which cases µVision shows the following error: Commandnot supportedError: Flash Download failed - Target DLL ha...
Supported programmers From ST exists actually three different SWD programmers: Full support: ST-Link/V2 ST-Link/V2-1 ST-Link/V3 Not supported: ST-Link/V1 Minimum recommended firmware version of ST-Link isV2J32xxor newer. Otherwise is recommended upgrade usingST-LINK firmware upgrade tool. ...
keil 使用STlink下载程序时提示command not supported 在使用STlink下载程序时候,先提示 “command not supported”,接着又弹出来一个“target DLL has been cancelled”;然后查看debug的时候,在SW device 能正常显示设备,经过多方排查,发现是如下问题 1:选中“option for target boot” 2:选择... ...
] is supported with V2J24xx or greater ST-LINK/V2 firmware version. When [ID=] and [SN=] are not specified, the first ST-LINK with ID=0 is selected. Selection of ST-LINK by ID or SN must be used with: • V1J13S0 or greater ST-LINK firmware version • V2J21S4 or greater...
Enhanced output for error msg addr not a multiple of pagesize, not supported (#663, #945) Updated STLink/V1 driver for macOS (#735, #964) Package distribution: Provide Windows binaries via Debian-based cross-build (#738, #795, #798, #870, #955) [refactoring] Update, corrections &...
In addition to what I wrote earlier, I saw on the list of J-Link supported devices that the entire STM32G4 is not supported (yet) by Segger. Again, I appears I am very early in adaptation cycle. The STM32G0, another new branch of the STM32 family, is supported by Segger. SEGGER...
I have installed STM32CubeProgrammer now and while it does not work it gives a more useful info to why not: It says "Error: ST-Link V1 not supported" I didn't knew it would be V1, I always was under the impression it would be V2, and it worked with all 'STLink/V2' tools u...
3. Automatic firmware upgrade is supported. The firmware has been upgraded to the latest V2.J17.S4 at the factory; 4. Add 5V power output, and the output I / O port is protected, not afraid of LINK ST V2 damage caused by Operation errors! 5. The interface uses pure copper gold-pla...
STVD Version 4.2.1 (and above) STVP Version 3.2.3 (and above) IAR EWARM版本6.20(及以上版本) IAR EWSTM8 Revision v1.30 (and above) KEIL RVMDK Revision v4.21 (and above) ATOLLIC TASKING Supported Devices Supports all STM8 series microcontrollers with SWIM interface ...