The markings are provided with the kit.I have read different modelers' methods on doing this scheme—one modeler paints the whole upper side Giallo, then adds the Bruno, then finishes with the Verde. Another shoots the green base, then adds the spots. Some use stencils, some do it free...
If a cart, etc., is used, please observe all safety markings and instructions that accom- pany the accessory product. SPECIFICATIONS SUBJECT TO CHANGE: The information contained in this manual is believed to be correct at the time of printing. However, Yamaha reserves the right to change or...
EN SPECIAL MESSAGE SECTION PRODUCT SAFETY MARKINGS: Yamaha electronic products may have either labels similar to the graphics shown below or molded/stamped facsimiles of these graph- ics on the enclosure. The explanation of these graphics appears on this page. Please observe all cautions indicated ...
In using the GRA-71, the operator manually keys in an encrypted morse code message on a magnetic tape cartridge. This tape is then used to drive a keyer connected to the GRC-109 transmitter – which then transmits the message at 300 words-per-minute (WPM). Obviously a shorter transmission...
ᕢ Insert the six new batteries, being careful to follow the polarity markings on the inside of the compart- ment. ᕣ Replace the compartment cover, making sure that it locks firmly in place. NOTE • Connecting the AC power adaptor automatically supplies power from the adaptor and ...
ᕢ Insert the six new batteries, being careful to follow the polarity markings on the inside of the compart- ment. ᕣ Replace the compartment cover, making sure that it locks firmly in place. NOTE • Connecting the AC power adaptor automatically supplies power from the adaptor and ...
If a cart, etc., is used, please observe all safety markings and instructions that accompany the accessory product. SPECIFICATIONS SUBJECT TO CHANGE: The information contained in this manual is believed to be correct at the time of printing. However, Yamaha reserves the right to change or ...
- Always make sure all batteries are inserted in conformity with the +/- polarity markings. - When the batteries run out, or if the instrument is not to be used for a long time, remove the batteries from the instrument. - When using Ni-MH batteries, follow the instructions that came ...