spanning-tree port type normalvpc 106 === When i let the two ports UP both of them start flapping and then they go down, but when i shutdown the second port it works, now i working with just the port channel of the N9K1, i tried to understand the issue but i don't find why w...
spanning-tree port type normalvpc 106 === When i let the two ports UP both of them start flapping and then they go down, but when i shutdown the second port it works, now i working with just the port channel of the N9K1, i tried to understand the issue but i don't find why w...
spanning-tree port type {edge [bpdufilter | bpduguard] | network [bpduguard] | normal [bpduguard]} default no spanning-tree port type default Configures all switch interfaces as edge/network/normal ports. These ports can be connected to any type of device. The no form of the command ...
The default spanning tree port type is normal. You can configure the port type either globally or per interface. Depending on the type of device to which the interface is connected, you can configure a spanning tree port as one of th...
A PortFast normal port—is the default type of spanning tree port. Note Beginning with Cisco IOS Release 15.2(4)E, or IOS XE 3.8.0E, if you enter the spanning-tree portfast [trunk] command in the global or interface configuration ...
全局模式下有三种spanning tree port： Edge，Network，Normal。Edge—Edge ports are connected to hosts...
The PVST mode's compatibility with the other spanning tree mode varies by port type: · On an access port, the PVST mode is compatible with any other spanning tree mode in any VLAN. · On a trunk or hybrid port, the PVST mode is compatible with any other spanning tree mode in only...
To Enable or Disable Fast Mode for a Switch Port: You can use either the CLI or the menu interface to toggle between STP Fast mode and STP Normal mode. (To use the menu interface, see "Menu: Configuring 802.1D STP" on page 6-22.) Syntax: spanning-tree < port-list > mode For ...
Port Types Port type is a configurable parameter that reflects the type of network segment that is connected to the port. Proper port type configuration results in rapid convergence after network topology changes. RSTP port types include normal, network, and edge ports. Normal is the default port...
The Switch 2 Port 2 is connected to Switch 3 Port 1. Switch 3 We could see here that the status of the second port of the Switch 3 is Blocking. This is the normal behavior of the Spanning tree, all the network are available and the best route from Switch 3 to switch 1 (The root...