Spanning Tree Protocol (STP) 的主要目的是**在数据链路层(Layer 2)消除网络中的环路,保持网络拓扑的无环状态**。具体分析选项如下: - **A.防止路由环路**:路由环路发生在网络层(Layer 3),而STP作用于数据链路层,此选项错误。 - **B.创建默认路由**:默认路由是路由器(Layer 3)的功能,与STP无关。 - ...
2. Types of Spanning Tree Protocol[1] 802.1D –This is also known as CST (Common Spanning Tree). It is a spanning tree standard developed by IEEE which elects only one root bridge per whole topology. All the traffic flows over the same path (the best path to the root bridge) but th...
解析:Explanation:STP’s main task is to stop network loops from occurring on your Layer 2 network (bridges or switches). It vigilantly monitors the network to find all links, making sure that no loops occur by shutting down any redundant ones. STP uses the spanning-tree algorithm (STA) to...
Central to the way that spanning tree protocols operate is the use of bridge protocol data units (BPDUs). When you enable spanning tree protocols on Layer 2 devices on a network, the devices send BPDUs to each other, for the purpose of learning the redundant paths and updating their L2 f...
Spanning Tree Protocol (STP) is a network protocol which runs on bridges and switches. The main purpose of STP is to prevent the bridge loop by providing redundant paths in the network as loops are deadly to a network. It also provides automatic backup paths ...
Purpose of Spanning Tree (3.1.1) The focus of this topic is to describe how Spanning Tree Protocol can solve common looping problems in a redundant switched network. Redundancy at OSI Layers 1 and 2 (3.1.1.1) The three-tier hierarchical network design that uses core, distribution, and access...
Spanning Tree Protocol (STP) is a Layer 2 protocol that aids in preventing loops in Ethernet networks, such as a local area network.
网络释义 1. 生成树协议 生成树协议(spanning-tree protocol)由IEEE 802.1d标准定义生成树协议的作用是为了提供冗余链路,解决网络环路问题 生成 … baike.baidu.com|基于197个网页 2. 树协定 扩充树协定(Spanning-Tree Protocol)也是启用的,并且容许桥接器能够跨越扩充的区域网路来建立一组无回路拓朴(loop-free top...
However, what is the purpose of the root bridge? What is it used for? Spanning tree architecture is like an inverted tree with an elected switch as root-bridge, which is root of the tree at the top by which all traffic must flow through. then the blanches of the tree which are the ...
Spanning tree was standardized in the IEEE 802.1d specification. The purpose of the spanning tree protocol (STP) is to identify and temporarily block the loops in a network segment or VLAN. The switches run the STP, which involves electing a root bridge or switch. The other switches measure ...