The results of thermobarometry shown here constrain the depth and dip-angle of the Farallon plate during this period, and so the thickness of the SCLM below the Colorado Plateau (see Supplementary Methods). In a two-layer model that considers representative densities for the upper and lower con...
However, in specific regions on the windward surface of the building, the y+ values are relatively large, approximately 30. Nonetheless, these values still comply with the computational requirements needed for accurate simulations. Figure 7 gives a flow chart of the numerical simulation process. ...
To avoid local failure phenomena during loading in the finite element software, an elastic block with a thickness of 20 mm was added on the top surface of the column. The finite element model of the slab–column connection is shown in Figure 8. To minimize errors, displacement values were ...
Black markers on the curve identify the IM levels at which seismic analysis will be performed. Two horizontal dotted lines are superimposed on the chart to identify the MAF corresponding to two main limit states considered in this study: Damage onset (blue) and Near-Collapse limit states, ...
Nozzle port area Nozzle port angle Mold thickness Mold width (w) Strand geometry Domain length Steel flow rate Casting speed Tundish height Steel grade Shell thickness profile Slide-gate open-area fraction Slide-gate opening direction Inclusion size range (diameter) Submergence depth of nozzle Caster...