The LTTP2 may be installed vertically on the wide face of a minimum 2×4 stud for holdown applications and can be fastened with nails or Strong-Drive® SD Connector screws. “The one-piece design of the tested, code-listed LTTP2 si...
The LTP4 is approved for installation withStrong-Drive®SD Connector screws. Allowable loads are for one angle. When angles are installed on each side of the joist, the minimum joist thickness is 3". Some illustrations show connections that could cause cross-grain tension or bending of the ...
Allowable Stress Design (ASD) Method and Strength Design (SD) Method Information Suggested Specifications (2012 CSI Format) and General Notes for Anchoring Systems Glossary of Common Terms for Anchoring and Fastening Systems Anchoring Adhesives