Is there a possibility/option to enlarge the "show Fiber Direction"-arrows in Ansys ACP (Pre)? For reasons of viewing. (green arrows in the picture below)
Your picture shows that you are not using Fluent Meshing, which is native in the Fluent Launcher. You are using ANSYS Meshing (which uses the same GUI layout as Mechanical) to make a mesh for Fluent as the outline tree shows you used a Mesh Component System in Workbench. ...
1 开启Mesh功能 SCDM的网格功能正常情况下是被隐藏的,通过以下方式开启: 启动ANSYS Workbench,选择菜单Tools → Options…打开选项设置窗口 如下图所示,选择节点Appearance,右侧面板中激活选项Beta Options 2 功能演示 在Workbench中添加Geometry模块 进入Geometry模块,绘制如下图所示图形 对于如图所示的几何,不进行处理的话...
Continue analysis with new mesh antype, , rest, , , continue solve finish 映射好的0.9秒网格: 最终结果。这个网格还很顺眼~ 最终状态的von-Miese应力,做个1/2的轴对称延伸: 嗯,美得很美得很~ 4. 后记 在本案例的学习过程中,我了解了ANSYS和Abaqus在塑性本构模型功能上的异同,也看到江丙云博士主编的《A...
Keyur Kanade Ansys Employee after subtraction, please do share topology and check if the connections are ok. also check fault detection/check geometry. as a starting point, i suggest you take only couple of those wavy geometries, subtract and mesh. Then add one more wavy geometry and so ...
再下一步,remesh,read,mesh1,cdb。读取文件夹里已有的mesh1.cdb文件。这个是根据0.7秒的模型,用任意前处理器重画好的网格。 finish应该不用多说了。 接下来就是mapsolve,500,pause。完成finish命令以后,GUI界面上才会出现这个按钮。 映射结束,就是又一波clear。然后进行重启动分析。
3 ANSYS2020-Mesh总体尺寸控制-刘尧.mp4 是在优酷播出的教育高清视频,于2020-04-29 16:47:53上线。视频内容简介:3 ANSYS2020-Mesh总体尺寸控制-刘尧.mp4
8 ANSYS2020-Mesh流固CutCell网格CFD-刘尧.mp4 是在优酷播出的教育高清视频,于2020-04-29 19:03:29上线。视频内容简介:8 ANSYS2020-Mesh流固CutCell网格CFD-刘尧.mp4
Depending on whether or not your chosen material is in the simulation database — and sometimes even if it is — analysts will have some important choices to make and factors to be aware of. Learn them here. How to Achieve Simulation Success, Part 1: Model Accuracy and Mesh Decisions ...
Did you check in the OpenFOAM-2.1.x/etc/config/settings.sh (or the one corresponding to your shell) if the correct C++-compiler is set there? I just had serious build problems because I had not set the gcc46 manually... Posts: 1 ...