In this work, a new specimen is introduced to measure the ratio of tensile strength and shear strength under quasi-static conditions and different strain rates just by conducting some simple tension test. Three different materials, aluminium, brass and steel, are used to address generality of the...
拉伸剪切强度。搭接接头在拉伸载荷作用下破坏时单位胶接面所承受的应力。
n A measure of the shear strength of an adhesive bond in which two members are bonded in a Lap Joint, then pulled at both ends until the joint fails in shear. The strength is reported as the tensile force divided by the shear area (Pa). A double lap joint may be specified. Many ...
The mechanical properties of environmentally-friendly fiber metal laminates (EFFMLs) with jute (J)- basalt (B) fibers as a hybrid reinforcement and aluminum (Al) 2024-T6 as a skin, as well as an epoxy serving as a matrix, were investigated by employing tensile and interlaminar shear tests....
Knowledge of the physical properties of lignocellulosic biomass is important for the design and execution of field operations such as harvesting, baling, and size reduction. In this study, the tensile strength and the shear strength of Kanlow switchgrass before and after frost for internodes 2 and...
源于网络翻译，仅供参考 tensile shear strength 剪切强度;拉伸剪切强度 不知道楼主做的是何种胶黏剂？胶黏剂的测试里有Lap shear strength，就是说的剪切强度.希望对你有帮助
macroscopic shear strength, tensile strength, and deformation behavior. This was accomplished by conducting a large suite of direct shear and direct tension tests using three gradations of Ottawa sand prepared to relatively "loose" and relatively "dense" conditions over a range of degrees saturation....
翻译为：tensile shear strength 网络：剪切强度; 拉伸剪切强度 例句：The corrosion resistance of epoxy adhesive was assessed by its tensile shear strength.环氧胶粘剂的耐蚀性能是通过测定其拉伸剪切强度来评定的。
The effect of adhesive thickness on tensile and shear strength of a polyimide adhesive has been investigated. Tensile and shear tests were carried out using butt and single lap joints. Commercially available polyimide (Skybond 703) was used as adhesive and aluminum alloy (5052-H34) was used as...
ALSO, IT WAS FOUND THAT THE ULTIMATE SHEAR STRESS WAS APPROXIMATELY 73 PERCENT OF THE TENSILE STRENGTH FOR A325 BOLTS TESTED IN COMPRESSION JIGS AND APPROXIMATELY 68 PERCENT WHEN THESE BOLTS WERE TESTED IN TENSION JIGS. FOR A354BC, A354BD, AND A490 BOLTS, THE CORRESPONDING VALUES WERE 69 ...