SGMII SFP Transceiver光模块 简介 Compliant with SFP+ MSA: INF-8074iCompliant with SFF-8472 Rev9.5Compliant with IEEE802.3-2005Compliant with G.957ESD to the Electrical PINs: compatible with MIL-STD-883E Method 3015.7 方法/步骤 1 Connection Gigabit Ethernet To Fast Ethernet 2 Switch to Swit...
The transceiver consists of two sections: The standard SFP part and the PHY part built with SGMII interface. The optical output can be disabled by a TTL logic high-level input of Tx Disable, and the system also can disable the module via I2C. Tx Fault is provide...
The SFP transceiver is high performance, cost effective modules. It is designed for 100BASE-LX applications of 10km with SMF. The transceiver consists of two sections: The standard SFP part and the PHY part built with SGMII interface. The optical output can be disabled by a TTL logic high-l...
Form Factor: SFP Device Type: Transceiver module Interface (Bus) Type: Plug-in module Connectivity Technology: Wired Application: FE/GE Data Transfer Rate: 100Mbps Wavelength: 1310nm Max Distance: 10km Fiber Type: SMF Connector: Duplex LC DDM: Without DDM Operating Temperature: 0~70 °C Compl...
Form Factor: SFP Device Type: Transceiver module Interface (Bus) Type: Plug-in module Connectivity Technology: Wired Application: FE/GE Data Transfer Rate: 100Mbps Wavelength: 1310nm Max Distance: 2km Fiber Type: MMF Connector: Duplex LC DDM: Without DDM Operating Temperature: 0~70 °C Compli...
This reference design has been validated with the FS, TechNxT, and Finisar SFP RJ45 transceiver modules. The following lists the details of the modules: • FS SFP: Generic Compatible SFP SGMII 10/100/1000BASE-T Copper 100m RJ-45 Transceiver Module • TechNxt SFP: TechNxt 1G copper RJ-...
24/32/48 Altera FPGA Backplane Driver Can be AC or DC coupled, depending on connection feasibility of the system Line Cards Slot Slot Switch Slot Backplane Chassis Figure 2: SGMII Connectivity Using an Altera FPGA through Copper SFP Transceiver The PHY device is part of the copper SFP module....
Stratix III Soft-CDR Interfacing with a Copper SFP Transceiver Figure 3 shows typical SGMII system connectivity using a Stratix III device connected to a copper SFP module. Figure 3. SGMII Connectivity Using Stratix III Device with Copper SFP Copper cable 10/100/1000Base-T Typically 16 to 48 ...
The PHY I'm looking for would support converting from the wired PHY interface of the daughter card to the SFP socket. This design would allow the user to select an SGMII SFP module to use in his application of our PCB. Hope this make it clear. Thanks again! Best Regard...
3 Lattice Semiconductor LatticeSC/Marvell Serial-GMII (SGMII) Physical Layer Interoperability Figure 2 illustrates the SMB-2000 analyzer with a 1000BASE-T copper module (GX-1420B, right-most module with RJ45 cable attached). Figure 3 illustrates the GUI command console for the SMB-2000. The GX...