我有两台SG300-28两台和一台52的。忘记了所有的账号密码。所以必须重置配置。。用crt通过console口怎么也连接不上。。。波特率是9600,8位,停止位1,基本上所有波特率都试过,都进不去。看到说可以reset,就用回形针插了reset口,开机状态下插了10秒,接口等全亮,闪了两次,重启,然后通过192.168.1.254来访问web的管理...
SG300-52 Continuous Reboot after TCP Congestion Avoidance engaged alex.gielis Level 1 03-13-2012 09:27 PM Hi All, I have an SG300-52 gigabit switch that has been constantly rebooting and is effectively unusable. This started after Enabling TCP Congestion Avoidance, sp...
How to track down STP issues with SG300-52 and SG300-28 - password of debug-mode debug command? Go to solution mmuellerde Level 1 08-23-2013 08:00 AM Hello *,actually I'm trying to track down and identify serious STP loop problems at my SG300-x...
I need a hand on a Cisco SG300-52 switch in regards to transfer speeds. I have a full Gigabit network, with CAT6 cabling as well, everything is Gigabit spec. I start transferring files across my network (early in the morning, so there is little to no traffic) and...
Is the router doing the interVLAN routing or is it one of the SG300? If the router, then what you need to do is carrying all the VLANs across the switches where they need to be; so for example, the link between your router and switch 1 needs to be a trunk (general mode is ok...