I started a firmware upgrade on the SG200-08 to 1.0.8.3 but unfortunately in this process the power failed. Now the switch is blinking on all LED. Starting the recovery over the web interface on 192.168.1.254 the progress bar runs to 100% and then the response to pings stops after a ...
Hi, I have upgraded my SG200-08 switches from firmware version 1.0.5.1 to version 1.0.6.2. Since that new firmware is active, the network-printing from my Macbooks and iMacs is not working anymore. They all have TCP/IP connected network printers
下载 喜欢 全屏标准 页码共182前往 Cisco Small Business Serie SG 200 8-Port Smart Switch ADMINISTRATOR- HANDBUCH 123…182
But if that started on its own it could indicate a problem with the firmware. The LED should blink if the switch has not seen a DHCP server and is using its default IP address. Make sure your network card is in the same subnet as the switch in its default condition. i.e. set a...
But if that started on its own it could indicate a problem with the firmware. The LED should blink if the switch has not seen a DHCP server and is using its default IP address. Make sure your network card is in the same subnet as the switch in its default condition. i.e. set a...
Going into the Switch’s firmware, at the LAG Management Table, I placed both NIC cables into ch1 (and named it TEAMING), set it as Static and have both g1 and g2 as the only members. Ch1 shows its Link State as Up, with g1 and g2 as the Active Members. There are no Standb...