The sg_reset utility with no options (just a DEVICE) reports on the reset state (e.g. if a reset is underway) of the DEVICE. When given a --device, --target, --bus
Reset 1个 (复位按钮) 天线接口 4个 (4G/5G天线,阻抗50欧,SMA阴头内孔接口) 4个 (2.4G/5.8天线,阻抗50欧,SMA内针接口) 1个 GPS(选配) 电源1+1备份 9~36V冗余电源,采用凤凰端子,外置电源适配器(支持轨道安 装),适配器采用工业级 Console口 1*(RS232 RJ45) 串口 1*485、1*232 指示灯 Byp...
按钮---RESET按钮 指示灯--- 电源、状态指示灯 尺寸(L x W x H)--- 158mm x 100mm x 25mm 交换方式--- 存储转发(Store-and-Forward)、线速过滤和转发 电源--- 外置电源适配器 过滤和转发速率 10Mbps:14880pps 100Mbps:148800pps 1000Mbps
Xil_DCacheFlushRange((INTPTR)DMA_Desc, sizeof(DMA_Desc));//数据cache flush刷新;将内存的数据刷到cache中,保证CPU读取的数据是最新的,而不是之前cache中缓存的过去数据; } void DMA_Init(void)//DMA控制器初始化 { // reset Xil_Out32(AXI_DMA_ADDR+XAXIDMA_CR_OFFSET, XAXIDMA_CR_RESET_MASK)...
-b,--busattempt a SCSI bus reset. A bus reset is a SCSI Parallel Interface (SPI) concept not found in modern transports. A recent LLD may implement it as a series of resets on targets that might be considered as siblings to the target on theDEVICEpath.-d,--deviceattempt a SCSI devic...
create 2 vms with with vhost-user-scsi-pci device using vhost.0、vhost.1 after vms running,running fio in one vm,and executing sg_reset -d in anothervhost crash: vhost: nvme_pcie.c:1069: nvme_pcie_qpair_complete_tracker: Assertion `cpl->cid == req->cmd.cid' failed....
• Guaranteed /RESET Valid at VCC = 1V • 200ms Reset Pulse Width • Debounced TTL/CMOS-Compatible Manual-Reset Input • Independent Watchdog Timer (1.6sec) Timeout • Voltage Monitor for Power-Fail or Low-Battery Warning • -40℃ to +85℃ Operating Temperature Range ...
1、Intellisys SG 控制器面板设置控制器面板设置MAINSTATUSSELECT MAIN MENUOperator SetpointsOptionsSensor CalibrationAlarm HistoryClock FunctionsIntegral Sequecing OPERATOR SETPOINTLead / LagOffline PressureOnline PressureLag Offset0 - 3.0 BarMode Of OperationMax Modulation PressLoad Delay0- 60 secStop Delay10...
reset. sg_reset_wp RESET WRITE POINTER getopt f,s,t,w sends this command to a ZBC (aka shared magnetic recording [SMR]) device. The corresponding ATA standard is known as ZAC. sg_rmsn READ MEDIA SERIAL NUMBER getopt f,s,t,w Relatively new command added to SPC-3. Format of response...