for core 0 here, to run once:SerialASC.begin(9600);// Fast!Serial.begin(9600);Serial.begin(9600);Serial.begin(9600);} /* Serial.read -- Ready ReadSerial0.read -- Ready ReadSerial1.read -- Do notRead ***Serial2.read -- Do not ***Serial1 RX1/TX1 Arduino...
for core 0 here, to run once:SerialASC.begin(9600);// Fast!Serial.begin(9600);Serial.begin(9600);Serial.begin(9600);} /* Serial.read -- Ready ReadSerial0.read -- Ready ReadSerial1.read -- Do notRead ***Serial2.read -- Do not ***Serial1 RX1/TX1 Arduino...
// check if line is empty, do not store empty lines if(num!=0) { // set parameters of DLT message to be generated msg.clear(); msg.setEcuid(""); msg.setApid("SER"); msg.setCtid("ASC"); msg.setMode(QDltMsg::DltModeVerbose); msg.setType(QDltMsg::DltTypeLog); msg.setSubt...
That's a good question because there are lots of ways this can fail. UsingGET A$, as your program does, is the way to go. I have an old Super Serial Card, but I haven't used it in quite a while. I do remember that absolutely all of the settings had to be correct on both si...
bytes depending on how the application is structured, and these bytes are further packaged into PDU’s. If your application is presenting the data to the user you have to ask yourself if the user interface can be updated at the actual PDU arrival rate, and if it can’t what do you do...
st-asc.c stm32-usart.c stm32-usart.h suncore.c sunhv.c sunplus-uart.c sunsab.c sunsab.h sunsu.c sunzilog.c sunzilog.h tegra-tcu.c timbuart.c timbuart.h uartlite.c ucc_uart.c vt8500_serial.c xilinx_uartps.c zs.c zs.h vt Kconfig Makefile amiserial.c ehv_bytechan.c gold...
I've read through this whole thread (and a few others) and everyone is saying to go get the driver from the prolific site, although I think that's now been taken down, as every link takes me back to the site index. If I search on their site for drivers, I can go to th...
To convert it to a real number so that the ISNUMBER function can read it, you have to hit it with any calculation and at the same time do not affect the value of the number such as+0. Finally, I would change the formula to make it more generic because the error handler is for the...
If the RAID controller isn't already showing an alarm on the drive, then it may be difficult to do via CLI. Suggest: Pull the drives and inspect the labels. There's a reason some of us tag the front of the drives with the serial numbers. Also, be aware, CCISS is known to be ...
When the advertising state changes, the gap_adv_state_changed (ASC, ID=4/2) API event occurs. This event includes the new state as well as a code showing the reason why the state changed. Note: If you do not have any automatic advertisement timeout...