(the sixth phase of the coupled model intercomparison project), and GEWEX-SRB satellite radiation products, the authors have quantitatively examined the ability of CMIP6 models to simulate the surface sensible heat flux over the TP during 1979–2014 and analyzed the possible causes of simulation ...
1993. Sensible and latent heat flux estimates in Antarctica. Antarctic Research Series, 61, 109-138.Stearns, C. R. , and G. A. Weidner ( 1993 ), Sensible and latent heat flux estimates in Antarctica , in Antarctic Meteorology and Climatology: Studies Based on Automatic Weather Stations , ...
Units are Wm ·decade . different seasons, and their influences on the trend in heat fluxes also vary. Compared with ENSO, the spatial Seasons AAO PSA1 PSA2 SOI patterns throughout the seasons of the trends in LHF and Autumn –2.8 - 3.9 – 1.4 - 2.2 –2.0 - 2.1 – 1.0 - 2.2 SHF...
Rambikur, E. H., and J. L. Chavez (2014), Assessing Inter-Sensor Variability and Sensible Heat Flux Derivation Accuracy for a Large Aperture Scintillometer Sensors, 14, 2150-2170; doi:2110.3390/s140202150.RAMBIKUR EH and CHAVEZ JL (2014) Assessing inter-sensor variability and sensible heat...
However, heat flux source area differences between the LAS and EC units may have contributed to some of the observed biases. Further, the overall conclusion of reasonable accuracy of was made, again partially due to potential for underestimation by the EC system. It is recommended, nonetheless, ...
Two eddy correlation units were operated in the daytime to measure the fluxes of sensible heat and water vapour and other turbulence statistics at various heights within and above the stand. Net radiation was measured above the overstory using a stationary net radiometer and beneath the overstory ...
Overall estimations of sensible and latent heat fluxes by the FV method were in close relation with the eddy covariance data. Keywords: flux variance; Monin–Obukhov similarity theory; sensible heat flux; latent heat flux1. Introduction Evapotranspiration (ET) is important for the precise use of ...
Therefore, the use of open-cell PCM-filled metal foams is a possible action that can be implemented to improve thermal conductivity and hence heat transfer. Medrano et al. [2] noted the advantages and disadvantages of these storage systems based on the experimental results of storage units in ...