SEEALSO systemd(1),sd-daemon(3),sd_listen_fds(3),sd_listen_fds_with_names(3),sd_watchdog_enabled(3),daemon(7),systemd.service(5) NOTES
经过反复测试,发现有如下的规律: (1): 上电之前插入装有MLO和u-boot.img镜像的SD卡,此时程序跑飞。最后打印如下: U-Boot 2016.01-g489ff5b-dirty (Dec 05 2016 - 15:04:34 +0800) AM335X-GP rev 2.1 Watchdog enabled I2C: ready DRAM: 128 MiB NAND: 128 MiB MMC: OMAP SD/MMC: 0 reg_base...
Other Parts Discussed in Thread:TPS65217,UNIFLASH am335x用sd卡启动后,应如何从sd卡烧写程序到emmc。 Hi ,Jian Zhou, 这是用sd卡升级的打印,请帮忙分析下,谢谢。 U-Boot 2015.07-00114-gf5078ef-dirty (Jan 25 2016 - 10:43:00 +0800) Watchdog enabled I2C: ready DRAM: 512 MiB NAND: 0 MiB...
sd_watchdog_enabled.xml send-unit-files-changed.c shutdown.xml standard-conf.xml standard-options.xml standard-specifiers.xml supported-controllers.xml sysctl.d.xml system-only.xml systemctl.xml systemd-analyze.xml systemd-ask-password-console.service.xml systemd-ask-password.xml systemd-...
Watchdog enabled DRAM: 512 MiB NAND: 512 MiB MMC: OMAP SD/MMC: 0, OMAP SD/MMC: 1 MMC: no card present ** Bad device mmc 0 ** Using default environment <ethaddr> not set. Validating first E-fuse MAC Net: Could not get PHY for ethernet@4a100000: addr 0 ...
Watchdog enabled I2C: ready DRAM:512MiB NAND:0MiB nand_init->xxxx/drivers/mtd/nand/nand.c MMC: OMAP SD/MMC:0, OMAP SD/MMC:1MMC->xxxx/drivers/mmc/mmc.c1 MMC->xxxx/drivers/mmc/mmc.c2 xxxx/common/env_common.c*** Error -No Valid Environment Area found*** Warning - bad CRC,using...
[ 1.048300] sun6i-rtc 1c20400.rtc: RTC enabled [ 1.052851] i2c /dev entries driver [ 1.057877] input: ns2009_ts as /devices/platform/soc/1c2ac00.i2c/i2c-0/0-0048/input/input1 [ 1.067389] sunxi-wdt 1c20ca0.watchdog: Watchdog enabled (timeout=16 sec, nowayout=0) [ 1.136223]...
Watchdog, etc. If a watchdog is configured systemd will kill the process whenSDNotify.sendWatchdog()isn't called every n seconds.isWatchdogEnabled()andgetWatchdogFrequency()may be used to determine if and at what intervalsendWatchdog()should be called. ...
犹豫前段时间⼀直在搞另⼀个项⽬，Am335x这个BBlack板就放置⼀边了。前⼏天把BBlack板重新拿到⼿，之前搞得给全忘了。SD卡烧写emmC时突然出现了错误，⼀直找不到原因，今天终于算是有点眉⽬了，就录下来省得下次⼜忘记了。之前不能分区出现的错误：log：*** Sitara Flash Fetcher is complete....
[ 0.254767] sun6i-rtc 1c20400.rtc: RTC enabled [ 0.254991] i2c_dev: i2c /dev entries driver [ 0.256126] sunxi-wdt 1c20ca0.watchdog: Watchdog enabled (timeout=16 sec, nowayout=0) [ 0.257159] sun4i-ss 1c15000.crypto: Die ID 7 [ 0.258064] usbcore: registered new interface ...