The error's title is: `SC_ERR_CTL_NO_TRG_POWER'. The error's explanation is: The controller has detected a target power loss. The user may have failed to turn-on or connect its source." After spending 2 hours of searching, I found the error was caused because ...
Measurements were performed using an excitation wavelength of 532.1 nm, a 50× objective, at a power close to 7 mW on the sample and 100 accumulations of 10 s per spectrum to improve the signal-to-noise (S/N) ratio. The spectra were calibrated using the 521 cm−1 line of ...