Please plug the USB cable gently, otherwise you may damage the interface.Please use the USB cable with 4 wires inside, the 2 wires cable can't transfer data. If you are not sure about the wire you have, you can click here to buy Mirror Installation you need to install the NPi i.MX6...
EASY INSTALLATION: JUST SLIP ON (SEWN END OVER SPARK PLUG) FOR MAXIMUM PROTECTION SLEEVES ARE HALOGEN FREE & NON CONDUCTIVE SLEEVES RESIST GASOLINE & ALL ENGINE CHEMICALS SPARK PLUG WIRE SLEEVES CAN REST DIRECTLY ON HOT HEADERS AND OTHER ENGINE COMPON...
Several years ago, FriendlyELEC launchedNanoPi NEOboard with Allwinner H3 quad-core Cortex-A7 processor followed byNanoPi NEO2upgrading to the Allwinner H5 64-bit Arm Cortex-A53 processor. Both boards target low-cost headless applications with I/O headers, USB and Ethernet, but while the NEO2 ...
The metal rod is still easily accessible, so you’ll be able to open the cover to install/replace an M.2 card or access the GPIO headers. The short video below shows how well the magnets work and how to remove the top cover. I’d like to thank Seeed Studio for sending ODYSSEY-X86J...
Connecting the hard drive Wire number 1 on the cable is red or blue, and the other wires are gray. 1. Connect one end of the cable to the IDE connector. Make sure that the red (or blue) wire corresponds to pin 1 on the connec- tor, which is labeled on the board (on the right...