内网双网口bonding 都是千M的，主交换机也是千M的，最近内网网卡 会出现Tx/Rx Errors 一天几十个，暂...
Received (RX) 72824 OK, 36413 errors Transmitted (TX) 30792 OK, 1 errors In my wrt54g if i chose the right antenna for reception and the left one for transmiision the number of error fell even if i use my bluetooth headset [edit] How can one avoid all these errors?
Re:Re:Re:Re:TX / RX Error Fast reply I haven't managed the same ap at the same location l2 and l3. I have 3x eap245v3. The one connected l2 has no errors or wrong counters. But the symmetric counters are wrong for the other two. should be same as the 2.4 band Interference is...
The TCAN4550 should be completely configured before being placed in Normal mode and clearing the Initialization (INIT) bit in the Control Register (0x1018[0])? Bus errors are usually caused by one of two reasons. The first is poor signal integrity from an improperly ter...
stats_tx->bytes = tx->bytes; stats_tx->errors = tx->errors; stats_tx->queue_restarts = tx->queue_restarts; } return tc < self->rx_rings && tc < self->tx_rings; }unsigned int aq_vec_get_sw_stats(struct aq_vec_s *self, const unsigned int tc, u64 *data) ...
On Linux, each network interface comes with several packet counters such as RX (number of received packets), TX (number of transmitted packets), errors (number of packets with errors), dropped (number of dropped packets) and overruns (number of lost packets due to queue overrun). You can ...
Given the drive to produce small packages where possible, it is tempting to place Rx and Tx lines in a link such that they are next to each other on the same edge of the package. This placement is done such that only one side of the package is needed to communicate with some periphera...
estimated and simultaneously, weighing in the adaptive antenna device in each of radio base stations is respectively determined so as to minimize the total sum of square errors between a received signal in all the plural radio base stations utilizing the same communication channel and a desired ...
BWchannel has to be larger than the maximum signal bandwidth BWsignal plus the maximum frequency error due to crystal inaccuracies. Worst case scenario will be for the crystal errors on Tx and RX side to be of opposite signs BWchannel > BWsignal + 4* XTALppm* fRF ...
So i've noticed that on both the 2.4 and 5 Wifi radios, the "main" SSIDs (ie wlan0 & wlan1) always have 0 errors for TX & RX, yet with the "VAP" SSIDs (ie. wlan0.1 & wlan1.1) the RX error counter is always ~10% of the total RX packet count. I've attached the wlan...