and i have seen it on multiwiiconfig.exe program. its working my receiver and gyro is working. after i calibrated my esc #define ESC_CALIB_CANNOT_FLY here and again i did it uncomment and i load to code to arduino. but when i connect my battery motors dont work. Reply Murat 9. ...
Today, I’d like toshow dotnethow to run your own .NET application on a Micro Controller Unit (MCU) on a simple battery for multiple years. I’ll build an application that will read the temperature and pressure on a BMP280 sensor connected to an ESP32. The core idea is to be run o...
After leaving it an hour, I decided to try it again. If I power it up either from the battery or from USB the LED blinks so the ESP32 is obviously getting power. But the board is no longer detected as a serial port by ...
I checked my mifi device to find that the battery had gone flat! This was the first time I'd used it, so it was surprising that the battery didn't last long at all. In fact, using it since then, strangely, it seems to last much longer. As we were right at the very end of th...
Out of interest, do you have the two 30kWh batteries connected to a common busbar, or do you maintain two independent battery banks? The reason I am asking is that if they are on one busbar you could do the setup as suggested and just use the YAML code to address all units using ...
This is NOT the standing no-load voltage. I would recommended that you unplug your Eon if you are away from your vehicle for more than a few hours and put a battery charger on your car's battery weekly to avoid wrecking your battery if your Eon stays powered when you shut off the ...
Making the board run properly on Arduino IDE (UPDATE: This is outdated. Check my newer post on this board). The serial output is wrong: One has to set Serial.begin(74880); on arduino code in order to get 115200 output on the serial monitor. This is because it uses a 40mhz crystal ...
(*) be careful with TTGO v2.1.6. Some boards are arisk of fireif you charge a battery. Important Attach the antenna before supplying the LoRa boards. If the antenna is not connected, this may damage the LoRa chip. DIY Project - LoRaWAN on ESP32 running MicroPython ...
The Arduino runtime must be taking the CPU out of interrupt level before calling burpcount. Spiney wrote:You must be right, the time probably does relate to compilation date. Battery is good, but I must assume a battery interruption. Your sketch will reset the RTC to the compilation time ...
Re: Running CPP code using ESP8266_RTOS_SDK#96538 Bymgerczuk-Sat Jun 17, 2023 7:54 am I guess I'm late, but I had the same problem and found a solution. The crash happens in the constructor of the global static object in <iostream> ...