It works to a certain degree. Sometimes the RTT Viewer throws the error message "Could not connect to J-Link." but since this a workaround I expected that something like this could happen. The only thing missing is performing "exit" if VTref reaches 0 again, but this might be a ...
In stand-alone mode RTT Viewer can retry to send input, in case the target input buffer is full, until all data could be sent to the target viaInput -> Sending... -> Block if FIFO full. Logging Data Additionally to displaying output of Channel 0, RTT Viewer can log data which is ...
The J-Link RTT Viewer Configuration dialog is used to set all necessary device specifics to successfully connect and read/send RTT data from/to the target device. J-Link RTT Viewer Config dialogConnection SettingsJ-Link RTT Viewer can be used in two modes: Stand-alone, opening an own conne...
My feeling is that in both cases we let enough time for RTTviewer to get the messages before starting zephyr scheduler. But adding traces in 'main' function (so after scheduling is started), those traces are not shown in RTTviewer with the same conditions. So Scheduling seems to be the k...
I am using Ubuntu16.04LTS in VMware player to try the RT117x SDK. I did two tests: Running JLink tools (GDBServer & RTTViewer) v6.98e at Windows host and gdb on Ubuntu side. Running Jboth Link tools v7.66 and gdb on Ubuntu side. In both cases, I can connect to t...
Say you are in a work, lab or other environment where you are not alone on the physical network and there could be overlap of IPs, but you need all of your VMs to be contactable from your host, VMs need to communicate with each other, and VMs need internet. NAT Network will give ...
Virtualbox is a very powerful tool, but for some use cases it is less than optimal. Say you are in a work, lab or other environment where you are not alone on the physical network and there could be overlap of IPs, but you need all of your VMs to be contactable from your host, ...
JLinkRTTViewer.exe --bright --deviceSelects the device J-Link RTT Viewer shall connect to. Syntax --device <DeviceName> Example JLinkRTTViewer.exe --device STM32F103ZE --connectionSets the connection type. The connection to the J-Link can either be made directly over USB, IP or using ...
qemu: could not load PC BIOS 'bios-256k.bin' The file exists here: /usr/share/qemu/bios-256k.bin It is symlinked to here: /usr/share/seabios/bios.bin A quick fix is manually specifying the BIOS: -bios /usr/share/qemu/bios-256k.bin... Hyper-V Linux VM Boots to Black Screen, ...
apt install tftpd-hpa #change TFTP_ADDRESS to by setting address to 192.168.1.1:69 or the IP you need, otherwise it will listen on all IPs and interfaces which could be a security risk. # edit /etc/default/tftpd-hpa TFTP_USERNAME="tftp" TFTP_DIRECTORY="/srv/tftp" TFTP_ADDRESS="192.1...