ESP8266的编程方式可以用官方的SDK编写,也可以用Arduino编写。各有各自的优点。如需查看Arduino搭建8266的开发环境可前往Arduino搭建ESP8266开发环境 首先我们前前往安信可8266系列模组专题:安信可 在这里有许多ESP8266的资料以及固件包: 同时提供了SDK开发环境搭建的资料,本次是使用Win10平台SDK NONOS 3.0对ESP8266对mcu...
改用vs code 作为开发环境 1.下载,安装vs code(省略) 2.安装arduino插件 3.设置 然后需要通过 文件菜单>首选项>设置 打开Visual Studio Code配置文件,在 4.开发程序 在状态栏中设置 按下CTRL+ALT+U键编译下载程序,验证程序是否执行 5.关于vs code 输出窗口中中文乱码的解决方案 打开控制面板... ...
然后是SDK,或者说支持的硬件,直接上图吧:我主要看重的是ESP8266,他们提供的开发方式有两种:一种是在arduino环境下开发,另一种支持安信可的一体化开发环境,但是仅支持最新的RTOS模式。 原谅我暂时的精神洁癖,放弃了arduino,我选了安信可一方。 最后是APP,他们的APP很有意思。安装好是这样: 打开后是这样: 第一次打...
ubxlib is supported as a PlatformIO library; if you have a board that either (a) runs Zephyr or (b) contains an ESP32 chip (running ESP-IDF or Arduino), then just follow the instructions here to load ubxlib directly into the PlatformIO Visual Studio Code-based IDE....
Note: the Arduino framework (NONOS 2.2.1, 2.2.2 and pre 3.0.0) does not disable the interrupts (timer 1 intrrupt work correctly in any condition) so I think about a bug. I'm still working on a workround to mitigate the timing issue, but I think that keep the level1 interrupt ena...
arduino_nicla_sense_me:samples/drivers/led_is31fl3194/sample.drivers.led.is31fl3194 ‑ samples/drivers/led_is31fl3194/sample.drivers.led.is31fl3194 arduino_nicla_sense_me:samples/synchronization/sample.kernel.synchronization ‑ samples/synchronization/sample.kernel.synchronization arduino_opta/stm32...
but the card does change bus speeds several times. The driver is designed to negotiate a clock speed of 50MHz, but the card starts at 400KHz. The errors you are seeing do all seem to occur at that higher clock speed, however it looks like the Arduino teensy SD driver also will run ...