Tip: Using a warm syringe will help make the extract pull easier through the nozzle; a few minutes near a heating pad would suffice nicely for this purpose. Place the end of the syringe into the oil and, drawing back gently on the plunger, fill with material to the desired amount. Repea...
If such a thing happens simply run hot water over the syringe and your doses can then be forced out much more easily. Sometimes a patient will force out too much oil, but if this happens just pull back on the plunger of the syringe and the excess oil can usually be drawn back into ...
Wipe away any excess solder paste from the syringe and replace the cap. Get into the habit of doing this immediately after each use to maintain the consistency of your solder paste for longer.Simple smt assembly processNeoDen provides a full SMT assembly line so...