An IS-IS route can take effect only after this IS-IS route has been successfully added to an IP routing table. If an IS-IS route does not need to be added to a routing table, specify conditions, such as a basic ACL, IP prefix, and routing policy, to filter routes so that only ...
Then, after the configuration is performed, the route on the stub router will not be selected. The link cost on the stub router is automatically set to the maximum value 65535, thereby preventing traffic from being routed to the stub router. This configuration task generally applies to device ...
A redistributed static route takes precedence over the summary route because the static route has an administrative distance of 1 while the EIGRP summary route has an administrative distance of 5. This happens when a static route is redistributed with the use of theredistribute staticcommand under t...
If an SRv6 locator is not specified in the route policy, the default locator configured under BGP is used to allocate the SID. If the default locator is not configured, then the SID will not be allocated. Per-CE allocation mode...
Transport security might be incorrectly configured, or the TCP/IP address for the route specifies a port that is being used by a service other than Service Broker. Note The port specified in the route must correspond to the port that is used by the Service Broker endpoint on the remote inst...
Perform this task to use both the automatically generated static route and the manually configured static routes to guide traffic forwarding. The task is applicable when the device has dual egress WAN links. This task enables the device to automatically generate a static route destined for the spec...
This command shows information about the SBD instance that is created whenevpn multicastis configured under an IP VRF: switch#show bgp evpn instance sbd redEVPN instance: SBD red Route distinguisher: 100:1 Service interface: VLAN-based Local IP address: 10.0.0.20 ...
RusRoute to user on the UDP port 10007, witch is to be shown by RRClient.exe. RRClient needs to be configured to work with the server. A new record is described by address of server, port (10000), gateway (optional, this gateway is to setup up default gateway with metric 20), ...
2. Create a static route group and enter its view. ip route-static-group group-name By default, no static route group is configured. 3. Add a static route prefix to the static route group. prefix dest-address { mask-length | mask } By default, no static route prefix is added to the...
1. Since the RG will only provide a route to the desired IP address via DHCP, can a virtual interface created via HSRP be configured to obtain an IP address via DHCP or will this require the installation of a third physical fastethernet interface in the 2811? 2. Once physical connectivity...