Default factory settings for Actiontec SG200 If you have performed a reset of your SG200 device or not changed the defaults, you should be able to access it with the following settings: Default subnet mask: 255.255.255.0 Note: If you are using the default settings you should change ...
Default factory settings for ASUS Tinker Board If you have performed a reset of your Tinker Board device or not changed the defaults, you should be able to access it with the following settings: Default Gateway IP:acquired via DHCPASUS login instructions ...
固定時間一過,交換器就會重新啟動。 步驟3.(可選)若要將交換器重新開機至出廠預設組態,請勾選Restore to Factory Defaults 步驟4.(可選)若要在重新啟動後清除交換器上的組態,請勾選Clear Startup Configuration File 步驟5.按一下Reboot。 注意:出廠設定中預...
Default factory settings for ZTE MF10 If you have performed a reset of your MF10 device or not changed the defaults, you should be able to access it with the following settings: Default Network name (SSID):ZTE Wireless Network Default Gateway IP:192.168.0.1ZTE login instructions ...
Default factory settings for TP-LINK CPE210 If you have performed a reset of your CPE210 device or not changed the defaults, you should be able to access it with the following settings: Default subnet mask:255.255.255.0 Note: If you are using the default settings you should change them to...
Default factory settings for ZyXEL WAP3205 If you have performed a reset of your WAP3205 device or not changed the defaults, you should be able to access it with the following settings: Default Network name (SSID):ZyXEL Default Gateway IP:192.168.1.2ZyXEL login instructions ...
Default factory settings for Xiaomi MiWiFi Nano (R1CL) If you have performed a reset of your MiWiFi Nano (R1CL) device or not changed the defaults, you should be able to access it with the following settings: Default subnet mask:
Default factory settings for Aruba Networks RAP-3WN If you have performed a reset of your RAP-3WN device or not changed the defaults, you should be able to access it with the following settings: Default subnet mask: Note: If you are using the default settings you should change them to inc...
If these instructions don't work for your router, you can always try a factory reset to get the default, or try some other common EnGenius credentials, as they can usually be shared across models/variants. Similar routers ESR6650 HSG200 ENHWI-3GN3 P.DG A2100N FortiAP-112B (FA...
Default factory settings for EnGenius ENS200 If you have performed a reset of your ENS200 device or not changed the defaults, you should be able to access it with the following settings: Default Network name (SSID):EnGeniusXYXYXYXYXYXY ...