One sample was collected on the FTA card and the other in a tube of liquid medium for HC2. The laboratory at University of Cape Town (UCT) performed the evaluation of the inter-laboratory agreement. The intra-laboratory reproducibility was studied by comparison of the results of two different...
In Europe outside Germany, sales for fiscal 2005 rose 7% year-over-year, to €24.429 billion, and orders were nearly level, at €26.150 billion. Within the Americas, sales in the U.S. for the full year increased 10%, to €14.686 billion, and orders rose 15%, to €15.867 billion, ...
As you read this article, you’re building your foundation for correctly applying the NEC. In fact, this article itself is a foundation for much of the Code. The purpose for the National Electrical Code is to provide a safe installation, but Article 110 is perhaps focused a little more on...
2 SME Requirements and Guidelines for the Design of Smart and Highly Adaptable Manufacturing Systems Erwin Rauch, Andrew R. Vickery, Christopher A. Brown and Dominik T. Matt 2.1 Introduction The industrial environment has undergone a radical change with the introduction of new technologies...
2 SME Requirements and Guidelines for the Design of Smart and Highly Adaptable Manufacturing Systems Erwin Rauch, Andrew R. Vickery, Christopher A. Brown and Dominik T. Matt 2.1 Introduction The industrial environment has undergone a radical change with the introduction of new technologies...
2.4.2. Evaluation of Model Predictive Skill Following model calibration, predictive skill at the two study sites was evaluated by applying the calibrated model (for each of the six bathymetries) to each of the calibration storms, as well as the "unseen" validation storms (refer Table 1 and ...
Analysis of differences between perpendicularity measurements applying ISO 1101/2012 and ASME Y14.5-2009 and its impacts. In Advances in Transdisciplinary Engineering; Volume 4: Transdisciplinary Engineering: Crossing Boundaries; IOS Press: Amsterdam, The Netherlands, 2016; pp. 1009–1018. Available ...
A further insight into and a confirmation of the effect of lift vector tilting can be obtained by investigating the lift characteristics of a wing at a large flapping angle, ν, and applying an aerodynamic method appropriate for such a complex wing configuration. For this purpose, the FLM-Eu ...