Do not plug a power cord from a device installed in one rack cabinet into a power device installed in a different rack cabinet. An electrical outlet that is not correctly wired could place hazardous voltage on the metal parts of the system or the devices that attach to the system. It is...
Disconnect the power cord from the rear of the product. Unplug the power cord from the wall outlet. Remove the printhead. You can leave the cartridges in the printhead. Lift the lever on the back right corner of the printhead assembly, and then lift out the printhead. 图片: Remove the pr...
Step 1: Attempted Repair... The white cord poking out of the electrical tape was a quick hack job I did last year to make this thing work. After strong winds blew the snowmen down the street on the first night we had it, I had to repair the missing prongs on the adapter. I pried...
Attach the power cable to the electrical outlet on the front of the power supply. Connect the other end of the power cable to an AC power source. For no power redundancy, connect one power supply to one power sour...
Step 8 Set the power switch to the on (|) position. Step 9 Verify the module's operation by performing the steps described here: Verifying the Power Supply Module Installation. Power Cord Retainer Mechanism This section shows how to correctly operate the power cord ret...
Do not plug a power cord from a device installed in one rack cabinet into a power device installed in a different rack cabinet. • An electrical outlet that is not correctly wired could place hazardous voltage on the metal parts of the system or the devices that attach to the system. ...
Power-Fan Input AC Power LED (Green) WARNING (W02) Risk of electrical shock – Before removing or installing a power supply, turn off the power switch, and unplug the power cord. If a fault is detected, the amber Power-Fan Service Action Required LED is on. If you can safely remove ...
Plug the cord back into the wall outlet. Press the Power button () to turn on the product. The product starts an initialization process, which takes a few minutes. It is normal for the product to make noises during this process. After the process completes, the product prints an alignmen...
Caution Do not touch the electrical connectors on the back side and do not set the back side connectors on anything—always set a fan tray down on a covered side to protect its connectors. Step 2 Install the new fan tray in the open slot as f...
Do not touch the electrical components or connectors on the module. Always hold the module by only its covered front and bottom sides. Press the ejector button next to the handle to release the handle from the front of the module (see Callout...