Before you remove the old hose, you need toempty the toilet tank. First, shut off the water valve by turning the handle clockwise as far as it will go, but that's not all you should do. Any water in the tank will pour onto the floor, so flush the tank, then hold down the handl...
Before working on any plumbing project, be sure to turn off the water. The water supply line to your toilet is connected to the wall or floor; simply turn the valve to stem the flow of water (Image 1). Flush your toilet and keep the handle down to empty the toilet of water. You’...
Replace Manual Toilet Joker ValveIn this video, we'll show you how to replace the joker valve in the Jabsco marine toilet. Make sure you have a 29092-1000 ready for replacement, some good protective gloves and remember to close the seacocks. 时长: 3:12 ...
If there is no shut-off to the water supply right at the toilet, you will need to turn off the nearest valve in the cold water line bringing water to the bathroom where the toilet is installed. Remove all of the water that you can from both the flush tank and from the toilet bowl...
To remove the old flapper, shut off the water to the toilet using the shutoff valve below the tank. Flush the toilet to empty the tank as much as possible. With the water supply shut off, it won't refill after you flush it. Taking a picture of the inner workings makes it easier to...
’” says Arnold. “Each fixture will have shutoff valves – one hot, one cold – to isolate it from the rest of the plumbing system. Anything past the shutoff valve, such as changing a spray nozzle, I consider to be DIY-friendly because the water can be easily shut off until a ...
Turn the water back on and test out the new flapper. Turn the water shutoff valve on the wall counterclockwise to restore the water and refill the tank. Wait a few moments for the water level to rise well above the flush valve, then press the handle. The toilet should flush immediately...
Turn off your main water supply or the valve to your shower. Then, pry off the cover on top of the knob and unscrew the screw. Twist and pull off the old knob and then push on a compatible replacement knob. Then, secure the new knob with a screw and push on the knob cover. ...
valve goes at the far end of the tube to keep water in the warmer environment of the house when the faucet is off. When properly installed at a downward angle toward the outside, the water drains out of the metal tube section onto the ground, so there's no water left to freeze. ...