Note that the handle will still be attached to the lock rod inside the door.Remove the screws that attach the interior door handle cup, door armrest and the triangular piece of trim at the upper front side of the door panel with a Phillips head screwdriver. Set all of the pieces aside....
Interior For an interior door, place the 2-foot level up against the door frame header, and have someone slide wedge spacers under the lower side jamb to bring up the header at its lower extremity. Measure the gap that the spacers added between the jamb and the floor and trim that much...
Insert the new lock piece with the screw holes and locking mechanism into the opening on the interior side of the patio door. Insert the back of the lock into the opening on the exterior side of the patio door. Hold the two pieces in place while tightening the screws. The two pieces wi...
Place the exterior handle on the door by inserting the spindle or axle on the handle through the latch cylinder at 90 degrees. Place the corresponding doorknob or lever on the interior side of the door, fitting the two parts together. It should feel slightly snug when the two parts join. ...
and the difficulty of the job depends on the wall material. If the door is an interior one, the walls are most likely drywall, which makes covering the opening an easy job. If the door is an exterior one, and the house is made of brick or stucco, the job is more difficult and may...
The stool is the interior molding that sits on top of the sill to give the frame a finished look. 3 Set the new window into the opening. Slip the bottom of the window onto the sill, then tip its top into place. Press the window against the exterior stops, and ensure it's centered...
The trim in the photos was shortened a bit and moved down on the inside and extended on the outside because the new door rests slightly lower than the old one. 33 Caulk around the trim or molding, inside and out. On an exterior door, this is weatherproofing; on an interior door, it...