Avoid contact with seats and inner door panel, Recommend assistance as requiredAlign cross car beam assembly to body and HVAC unit Note 4x datumsSecure upper steering column bracket IP carrier bolts at bulkhead Note 2x bolts, 13mm, 27 NmSecure cross car beam assembly to toeboard bracket N...
Release the main lower dash harness from the bulkhead. Release the motor bay harness from the bulkhead. Release the lower RH A-pillar connector bracket from the in cabin fuse box. Note Slide the bracket towards the rear of the vehicle to release it. ...
Release the clips (x2), grommet and connector for the rear LH door electrical harness seal at the B-pillar, and release the wiring harness from the B-pillar bulkhead. Pull the rubber grommet through the inside of the LH rear door, and then remove the LH rear door harness from the door...
Release all door harness clips. Push the wiring harness through the door bulkhead, and then remove the harness from the door. Remove the bolt that attaches the door check to the A-pillar. 24 Nm (17.7 lbs-ft) CAUTION Unbolting the door check allows the door to swing freely beyond openin...
Release the electrical harness boot, and then move the trunk electrical harness through the trunk lid bulkhead and out of the trunk lid. Release the clips that attach the LH and RH bump stops to the trunk lid, and then remove the stops from the trunk lid. Unscrew the LH and RH over-...
Remove interior HV harness bulkhead cover Note 3x nuts, 10mm, 9 NmRemove center floor lower support bracket Note 4x clipsRemove center console riser duct Note 2x clips, Maneuver forward to clear riser assemblyRemove floor jumper duct Note Push forward then lift and slide out...
Remove the nuts (x2) that attach the wiper mount bracket to the studs on the bulkhead (torque 20 Nm). Release the clips (x2) that attach the LH front air suspension line to the air suspension reservoir brackets. Release the nuts (x4) that attach the air suspension reservoir (torque 6...
Release the bracket that secures the HV connectors to the bulkhead. Disconnect the A/C compressor electrical connector from the HV harness. Install bungee straps to pull the LH and RH front wheel arch liners away from the HV battery and expose the coolant hoses. Perform a rear powertrain ...
Make sure tab is above the IP otherwise there will be a large gap near bulkhead Install bolts securing tuner bracket Note 3x bolts, 10mm, 6 Nm Connect the premium amplifier if equipped Note 1x connector, Fully seat connector, then engage locking tab ...
Correction code 15133202 0.06 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless e