https://drive.google...iew?usp=sharing I also uploaded with this post a small JPG(CN limits size). I am not sure where to start trouble-shooting. Consideration for a reflection in the imaging train (the inside of the OTA is flocked and the Celestron aluminum dew shield installed)? Back...
I picked up a Celestron Dew Shield and will set it up so it can be removed and installed without impacting the operating telescope. I'll post up some pictures later showing what I'm doing. Once up and running the plan is to install NINA and try the Hocus Focus plugin which is set up...
With the corrector installed and a "just snug" tightness for the dew heater ring fasteners I was ready to figure out a makeshift dew shield. A left over piece of flockboard worked out and should buy some time until I can come up with a real dew shield. Dew control was my main concern...
You are welcome. If you are OK with complicated filter swaps then stick with the Artesky adapter. It's an overall much simpler configuration except for filter swaps. For me, the Artesky adapter resulted in too much backfocus and there is no way to shorten it. I still think my RASA8 i...
Flats:how do you take flats? I assume it is valid question for any RASA/Hyperstar style of scope. Usually I put a screen in front of the dew shield but here the camera is way out. Brain&Force likes this #59 GazingOli Apollo
2. I have done nothing at all for cable management, other that run the cable in a straight line, out of the dew shield I use, which is cut out for Hyperstar. This will impact stars. There is a solution in the works for a 3D printed cabling system that I will test at another time...