being careful to minimize any waste as I want the side and end grain to match up as close as I can get it in the laminated and curved headboard cap. The strips are left a bit longer and wider to allow for easy cleanup after the lamination process. ...
The next step was to re-saw a single cherry board into three 1/4″ thick strips for the cap, being careful to minimize any waste as I want the side and end grain to match up as close as I can get it in the laminated and curved headboard cap. The strips are left a bit longer a...
aremove the valve cap of the inflator remove the valve cap of the inflator[translate] a如下规定 Following stipulation[translate] awhich shall be grouted into the deep bored hole and then allowed to solidify. The grouting shall not trap any air in the deep bored hole. 正在翻译,请等待...[...
Tacx does not have a 12mm hole through the hub like most other trainers do, so a 9 mm skewer and cap adapters need to be used. This does not work very well with R.A.T. You also might have to take the rear disc brake caliper off the frame on bikes with Flat mount brake mounts ...