The mechanical movement of the mmWave sensor system is precisely controlled by a combination of Arduino Uno and the digital stepper drive DM556. Arduino IDE script is used for the command and control of the movement. It is very important to synchronise the movement of the mmWave sensor system ...
mmWave RadarArduino Uno VCC 5V GND GND RX D2 TX D3Copy the following code to your Arduino IDE and upload it.Sample Code/*! @file DFRobot_mmWave_Radar.ino @ Read whether there is people or object moving in the detection range of the sensor. @ The sensor detection range and output ...
The proposed system uses a PC, a general purpose low-cost SDR platform and a minimum number of external components. The SDR platform is a USRP N200 equipped with a WBX RF daughterboard. The only external components are two off-the-shelf RF switches, an Arduino Uno microcontroller board, a...
The backscattered Tx signal is sampled at 4.5 kHz using the Arduino UNO analog-to-digital converter. Thereafter, the sampled signal is transferred to the MATLAB platform and analyzed using a customized FMCW radar algorithm. The proposed system is built using commercial off-the-shelf components, ...
The proposed system uses a PC, a general purpose low-cost SDR platform and a minimum number of external components. The SDR platform is a USRP N200 equipped with a WBX RF daughterboard. The only external components are two offthe- shelf RF switches, an Arduino Uno microcontroller board, a...