Using the Python language and libraries, designers can exploit the benefits of programmable logic and micro-processors to build more capable and exciting electronic systems.价格: $129.00 Purchase from our partner:
PYNQ-Z2 is a FPGA development board based on ZYNQ XC7Z020 FPGA, intensively designed to support PYNQ, a new open-sources framework that enables embedded programmers to explore the possibilities of xilinx ZYNQ SoCs without having to design programming logic circuits. Benefiting from programmable...
从TUL (tulembedded.com)网站中下载PYNQ-Z2板卡文件。直接下载链接:https://reference.digilentinc.com/learn/programmable-logic/tutorials/pmod-ips/start 将下载的板卡文件解压。 将板卡文件的文件夹pynq-z2复制到"C:\Xilinx\Vivado\2015.4\data\boards\board_files\"中。 启动Vivado,在创建新项目时候,即可看到PY...
TUL PYNQ™-Z2 board, based on Xilinx Zynq SoC is designed for the Xilinx University Program to support PYNQ (Python Productivity for Zynq) framework and embedded systems development. PYNQ is an open-source project from Xilinx® that makes it easy to design embedded systems with Xilinx Zynq...
• PYNQ-Z2 Board File (for Pmod IP support please refere here) (https://d2m32eurp10079.cloudfront.net/Download/pynq-z2.zip) • Master XDC (http://www.tul.com.tw/download/pynq-z2_v1.0.xdc.zip) • Protective Acrylic Case (PDF) ...
到这里我们可以顺带测试一下板子,jupyter 上打开文件 base --> board --> board_btns_leds 点击 运行,并一一运行完所有的代码块,在一排的黄灯闪烁一下之后,按下按键1,2,3,灯会有不同的变化(注意灯的顺序是从右到左的!)。而按下按键4,程序则自动结束。 (8)putty的使用 这一步是需要数据线一直插着的...
and programmed. PYNQ-Z2 board integrates Ethernet, HDMI Input/Output, MIC Input, Audio Output, Arduino interface, Raspberry Pi interface, 2 Pmod, user LED, push-button and switch. It is designed to be easily extensible with Pmod, Arduino, and peripherals, as well as general purpose GPIO ...
使用pynq_z2,我们首先要从官网下载boardfile。 https:///Download/pynq-z2.zip 解压,将文件复制到安装路径下。如图所示。 3. 新建一个vivado工程 1.1 vivado 部分 输入工程名字。next。 这里不需要添加源文件,勾选,do not specify sources at this time。next。
• PYNQ-Z2 Board File (for Pmod IP support please refere here)（https://d2m32eurp10079....
PYNQ-Z2 Board Setup Set the Boot jumper to the SD position. (This sets the board to boot from the Micro-SD card) To power the board from the micro USB cable, set the Power jumper to the USB position Insert the Micro SD card loaded with the image into the Micro SD Connect the USB...