The easy way to start is to use mpremote which allows a directory on your PC to be mounted on the host. In this way the filesystem on the host is left unchanged. This is at some cost in loading speed, especially on ESP32. In the micropython-micro-gui directory run: $ mpremote mou...
Start Order Request Contact Supplier Chat Still deciding? Get samples ofUS$ 1500/Piece Order Sample Shipping & Policy Shipping Cost:Contact the supplier about freight and estimated delivery time. Payment Methods: Support payments in USD Secure payments:Every payment you make on Made...
If this red alarm annunciation does not turn off after engine start, or after a failed start attempt, then it tells me that the circuit is still live and that I need to take immediate corrective action (probably very close to what happened to Brian DeFord in his Cozy burning-up incident)...
I’m talking about Tor relays (not client nodes). Look for the “cached-microdesc-consensus” file in any Tor installation, and you’ll have the full list (excepting “bridges”, which are only used for the first hop). The IP addresses and sometimes e-mail addresses are right there; b...
It's really a cost saver for us. Our electricity bills are so much lower, the air conditioning works better, you don't have light bulbs heating up the house, you don't have issues with changing them every five minutes because they're blowing, and it's really worked out for us." ...
Reporting that these DOD'installation sites'would be built near major airports to be usedif and when hospitals are unable to accommodate passengers in their own quarantine sites,those sites are located in the states of Hawaii, Illinois, Texas, California, Georgia, New York, Washington, New Jersey...
I then marked up and did an initial cut on the right side wall to start the trial & error process of getting it to fit.Here I’m about halfway through the process of fitting the right sump wall to the sump / fuselage floor.
The easy way to start is to use mpremote which allows a directory on your PC to be mounted on the host. In this way the filesystem on the host is left unchanged. This is at some cost in loading speed, especially on ESP32. In the micropython-micro-gui directory run: $ mpremote mou...
So today I set my sights on getting the wing NAV/Strobe and Wig-Wag lights wiring runs in the most unobtrusive, out-of-site way possible. As I mentioned at the start of this post, I had done a fair amount of research both in the plans, and online, in regards to drilling holes in...
This allowed me to better figure out where my oil lines will go inside the cabin for the oil heat system.I also did a fair amount of research on the FT-60 “Red Cube” fuel flow sensor installation, as well as the Matronix pulsation damper I have on hand.•••...