I discovered that ALL my aluminium materials lacked a completed material deffinition, and I learned that to edit the deffinition you need to right click the loaded material in the right pane labeled Materials in Model. I had to add the values of Poisson's Ratio and Young's Modulus whi...
9 members and the 3 reaction forces. Knowing the forces in each member allows calculation of the stress. The change in length is then calculated via the stress, Young’s modulus, and initial length. Then he calculated the deflection at the middle using the virtual work principle. Very ...
Is it possible to set Density for PTC_SYSTEM_MTRL_PROPS Is it possible to set default value to PTC_SYSTEM_MTRL_PROPS From a higher perspective, is it possible to configure default values of all parameters hosted by PTC_SYSTEM_MTRL_PROPS like: Description Poisson's Ratio Young's Modulus ...
So I found an appropriate Poisson's Ratio, Young's Modulus, UTS, etc. Entered them on the Structural page and hit OK. Now I get the error message: Parameter PTC_HARDNESS is not defined. The material is invalid. I have no idea where one would input PTC_HARDNESS, it's not on any ...
temperature, consisting of at least two different polymers, polymer-1 and polymer-2; wherein the melting temperature difference between polymer-1 and polymer-2 must be greater than 50掳 C., and the mechanical strength of polymer-1 as expressed by Young's modulus must be greater than 200 MPa...
temperature, consisting of at least two different polymers, polymer-1 and polymer-2; wherein the melting temperature difference between polymer-1 and polymer-2 must be greater than 50掳 C., and the mechanical strength of polymer-1 as expressed by Young's modulus must be greater than 200 MPa...
temperature, consisting of at least two different polymers, polymer-1 and polymer-2; wherein the melting temperature difference between polymer-1 and polymer-2 must be greater than 50掳 C., and the mechanical strength of polymer-1 as expressed by Young's modulus must be greater than 200 MPa...
temperature, consisting of at least two different polymers, polymer-1 and polymer-2; wherein the melting temperature difference between polymer-1 and polymer-2 must be greater than 50掳 C., and the mechanical strength of polymer-1 as expressed by Young's modulus must be greater than 200 MPa...