In this publication, it is also described that the composition is favorable as a vulcanization molding material of seal rings for FFV (Flexible Fuel Vehicle) fuel oil and can provide seal rings which are excellent in fuel oil swell resistance, low temperature properties, amine cracking resistance ...
In this process, reaction temperature (40, 50, 60 and 70 °C), methanol/oil molar ratio (3, 6, 9 and 12), NaOH amount as catalyst (0.5, 0.75, 1 and 1.25 wt%) and reaction time (60, 75, 90, 105 and 120 min) were assessed. After each reaction, the top layer ...
for 12 hours in an oil bath. Thereafter, while maintaining the temperature, 12.5 g (0.4 mol) of methanol was carefully added thereto followed by stirring for 3 hours. Thereafter, a low-boiling fraction was removed from the reaction solution, and water was added thereto followed by extraction ...
[21], where EE ranged from 57.73% (1:1 = protein:oil mass ratio) to 88.74% (4:1 = protein:oil mass ratio). Table 1. Total and surface oil content, encapsulation efficiency, oxidative stability index, and total peak area of selected volatile oxidation indicators of spray-dried emulsions....
Several bio-products can be extracted from its starch and used as an alternative for oil-based products. This study primarily aims to investigate the influence of the starch isolated from cassava peel on the quantity and quality of the biogas produced via anaerobic digestion. Beating pre-treatment...
Note that the effect from the cooling ratio and stress state was actually not taken into account. Finally, the thermal expansion measured on DED samples (Figure 9) and data found within the Metals 2020, 10, 1554 12 of 25 proportions. So, extracted data (Figures 9 and 10) were still not...