The port security policy on the interface was changed. Possible Causes The port security policy on the interface was changed. Solution Check whether the port security configuration on the interface is correct. If so, no action is required. If not, modify the configuration. Description Possible Cau...
in order to get rid of the 'Found duplicate mac-address', default the interface: 2950(config)#default interface FastEthernet0/1 Not sure if that is a flaw in PT, usually, 'clear port-security' should work. With regard to your second question, I don't see the static MAC address ? 6...
After port security is enabled on an interface, MAC address entries learned by the interface are stored in the MAC address table as secure dynamic MAC address entries. By default, secure dynamic MAC addresses will not be aged out. After the device restarts, secure dynamic MAC address entries ...
1. Configure port security on interface Fa 0/1 of the switch with the following settings : - Port security enabled - Mode : restrict - Allowed mac addresses : 3 - Dynamic mac address learning. 2. Configure port security on interface Fa 0/2 of the switch with the following settings : -...
Port security : Enabled AutoLearn aging time : 0 min Disableport timeout : 20 s MAC move : Denied Authorization fail : Online NAS-ID profile : Not configured Dot1x-failure trap : Disabled Dot1x-logon trap : Disabled Dot1x-logoff trap : Enabled ...
Do not enable 802.1X authentication or MAC authentication on a port where port security is enabled. After enabling port security, you can change the port security mode of a port only when the port is operating in noRestrictions (the default) mod...
Router# show vtemplate Virtual access subinterface creation is globally enabled Active Active Subint Pre-clone Pre-clone Interface Interface Subinterface Capable Available Limit Type --- --- --- --- --- --- Vt1 0 0 Yes -- -- Serial Vt2 0 0 Yes -- -- Serial Vt4 0 0 Yes -- ...
You can also attach the access session limit profile to an interface template. MAC Move When a MAC address is authenticated on one switch port, that address is not allowed on another authentication manager-enabled port of the switch...
01:11:14: %LINK-3-UPDOWN:Interface FastEthernet0/8, changed state to down A、其他交换机使用错误的电缆连接到该交换机端口。 B、未经授权的用户试图通过交换机端口 Fa0/8 telnet 到交换机。 C、路由器上启用了 NAT,同时有一个私有 IP 地址到达了交换机端口 Fa0/8。
An implementation of iOS 5+ Remote Virtual Interface service and pcapd. [3星][8m] [C] sizet/packet_capture 使用raw socket 和搭配輔助資料 (ancillary data (PACKET_AUXDATA), 適用於 2.6.21 之後的核心) 監聽和記錄 (pcap 格式) 乙太網路介面上傳送和接收的封包. [2星][3m] [Py] lucadivit/...