Port-group 1 Internet e0/0/1-2(进入端口0/0/1-2) Port-group 1 mode on/___/passive (手动/主动/被动)(将端口加入链路聚合组并选择模式) Internet port-channel 1(进入链路聚合组1) Switchport mode trunk (将链路聚合组开启TRUNK模式)相关知识点...
In Passive mode, the ports respond to LACPDUs they receive but do not initiate the LACP negotiation. If the physical switch is configured for active negotiating mode, it can be left in Passive Mode. If LACP needs to be enabled and Active mode is unavailable, it is highly possible that the...
[Sysname-Route-Aggregation1] lacp edge-port 1.1.9 lacp mode lacp mode passive命令用来配置端口的LACP工作模式为PASSIVE。 undo lacp mode命令用来恢复缺省情况。 【命令】 lacp mode passive undo lacp mode 【缺省情况】 端口的LACP工作模式为ACTIVE。 【视图】 三层以太网接口视图 【缺省用户角色】 network-ad...
TCP/IP mode -TCP Server / Passive mode Network Virtual Terminal(NVT) - On (only for recommended HWg devices) Serial port parameters Security All configuration settings in HW VSP3 are password-protected. To enter the password, press theLoginbutton. The default password is "admin". You can cha...
(config-if)#channel-group 1 mod on (config-if)#no shutdown (config-)#interface gigabitethernet 1/2 (config-if)#no switchport (config-if)#no ip address (config-if)#channel-group 1 mode on (config-if)#end copy run start 接入层交换机(3500xl)# ...
Using ion exchange in glass, Corning has developped the PhotocorTM range of passive multimode devices. This paper deals with the extension of the range to ... MM Court,JL Malinge - Fibre Optics 被引量: 0发表: 1988年 1-D And 3-D Analysis Of Multi-Port Muffler Configurations With Emphas...
I learned that LSF0108 supports both push-pull and open-drain mode output, my question is: 1) If I add external pullup resistor on one I/O port, so what's the output mode now? push-pull or open-drain and why?...
1. FTTX (FTTP, FTTH, FTTN, FTTC) 2. Local Area Networks (LAN) 3. Test Equipment 4. CATV 5. Analog/Digital Passive Optical Networks (PON) Compliance --Telcordia GR-1209 --Telcordia GR-1221 1×N PLC Splitter Specifications (Measured at room temperature and excludes connect...