The name server registration of the N ports logging in through an F port channel uses the fWWN of the port channel interface. DPVM configuration is not supported. You cannot configure the port channel port VSAN using DPVM. The Dynamic Port...
in Windows 8 / Server 2012 the powershell command , remove-printerport will remove WSD ports that did not get removed when the printer was deleted. Thanks for bringing this back so I would add the powershell command. remove-printerport -name WSDPORTNAME -computer Server2008R2machine Alan Mor...
Adding a printer port.Presents a tip regarding the use of two separate parallel ports in the simultaneous installation of dot-matrix and laser printers. Possible shortcomings of such a strategy.PoorAlfredPC Magazine
5. "Enter port name" supply value "\PrtServer\Share" (where the server and share are a Windows 2008 R2 server and the printer is already shared) Unless this method does not suit you for some reason. With this method you "only" need to look at the printer sharing permission on the a...
3-B-4. Enter the IP address or the DNS name of the machine, and click [Next]. The [Port Name] is entered automatically. If necessary, you can change it. When the next screen is displayed, follow the instructions on the screen. ...
I have to find anything specific to adding printer ports. When clicking "New Port..." I receive "Specified port cannot be added. Operation could not be completed (error 0x00000057)." All the forum posts are related to printer drivers, but mine is specific to adding ports. I don't know...
When a client prints to a printer port denoted as FILE, the client is prompted for the file name, and the output file is stored on the client computer. If you decide to add a new local port, you can enter one of the following: A file name, such as C:\dir\filename. All jobs ...
or maybe it works just fine for your needs, and you see no reason to spend money on a new machine. Or perhaps you got an older printer and can use that instead of buying a new one. In such cases, a trusty Ethernet connection comes in handy when adding your printer to the home netw...
so the messages could be transformed by the caller. I could then get rid of the current logic that waits within kubectl itself for the forwards to be up. But this got a little ugly when I then wanted to enrich the port mapping output to show the original port name/number requested by ...
For accepters, you generally do not need to specify the hostname if you want to bind to all interfaces on the local machine. Using a gensio Once you have created a gensio, it's not yet open or operational. To use it, you have to open it. To open it, do: struct gensio *io;...