i have two S5700Li switches and i want to do the stack [ACC-SW-1]stack port interface Gigabit Ethernet 0/0/49 enable Warning: Enabling stack port may cause configuration loss on the interface, continue?[Y/N]Y Error:The port is not allowed to enable to stack port. [ACC-SW-1] this...
After changing the default SSH port, you could not use the new port to log in to the ECS.The access to the new port is not allowed in the security group.The new port is n
You cannot remove a channel group, or add/remove any of its members. The channel group is removed when no member ports exist. About Autocreation The autocreation protocol has the following functionality: •A port is not allowed to be configured as part of a PortChannel when the autocrea...
Switch(config-if)# ip address 1.1.1.1/31 (config-if)#exit Switch# interface Ethernet1/10 Switch(config-if)# no switchport Switch(config-if)# logging event port link-status Switch(config-if)# channel-group 10 mode active command failed: port not compatible [Duplex Mode] ...
CPU architecture: ARMv8 [REQUIRED] description of errors confile log file 2021/02/22 14:23:39 [I] [proxy_manager.go:144] [543191d03372e531] proxy added: [download tcp] 2021/02/22 14:23:39 [W] [control.go:178] [543191d03372e531] [download tcp] start error: port not allowed ...
aDescription: 8080 is not an allowed port for Tunnel or SSL connections 描述: 8080不是一个允许的口岸为隧道或SSL连接[translate]
The InvalidWIDDBConfigPortNotAllowedIpamExceptionData complex type allows extended attributes on an ipam1:IpamExceptionData type. It creates objects whose IpamExceptionId is IpamApiErrorInvalidWIDDBConfigPortNotAllowed.<xs:complexType name="InvalidWIDDBConfigPortNotAllowedIpamExceptionData"> <xs:comple...
The VLANs allowed by the ERPS-enabled port are specified. After the control-vlan command is used in the ERPS ring view to configure a control VLAN and the port interface-type interface-number [ rpl owner ] command is configured, the ports in the ERPS ring allow packets of the control VLA...
WorkSpaces Web Access does not have control over the port that the browser selects. You must ensure that return traffic to this port is allowed.Domains and IP addresses to add to your allow list For the WorkSpaces client application to be able to access the WorkSpaces service, you must add...
configure the recovery mechanism from a Layer 2 maximum rate error so that the interface can be brought out of the disabled state and allowed to try again. You can also set the time interval. Errdisable recovery is disabled by default; when enabled, the default time interval is 300 se...