Most Cisco switches have a port in the notconnect state. This means it is currently not connected to anything, but it can connect if it has a good connection to another operational device. If you connect a good cable to two switch ports in the notconnect state, the link light must becom...
In a situation where you suspect port exhaustion, an application or process won't be able to release all the ports that it has consumed and will remain in the TIME_WAIT state. You might also see CLOSE_WAIT state connections in the same output; however, CLOSE_WAIT state is a state ...
You can determine if your port has been error disabled if you issue the show interfaces command. Here is an example of an active port: cat6k#show interfaces gigabitethernet 4/1 status !--- Refer to show interfaces status for more information on the command. Port Name Status Vlan Du...
The default value is tcp. -e <port_number> Specify the target port (also known as "endpoint") The <port_number> value represents the port to query on the destination computer. The default value is 80. -o <port_number>,<port_number> Specify multiple target ports in a sequence The <po...
If there is an error in the port configuration or there are insufficient ports in the pool, the Endpoint Mapper Service will not be able to register RPC servers with dynamic endpoints. When there is a configuration error, the error code will be 87 (0x57) ERROR_INVALID_PARAMETER...
Allowing users to open multiple remote sessions on Windows Server 2012 RDS Always prompt for password upon connection An authentication error has occured (Code: 0x607) an authentication error has occured. The token supplied to the function is invalid An Authentication Error has occurred (Code: 0x80...
DTS_E_COMPONENTHASINVALIDCLSID DTS_E_COMPONENTINITFAILED DTS_E_COMPONENTNOTFOUND DTS_E_COMPONENTNOTREGISTERED DTS_E_COMPONENTVERSIONMISMATCH DTS_E_COMPONENTVIEWISUNAVAILABLE DTS_E_CONFIGFAILED DTS_E_CONFIGFILEFAILEDEXPORT DTS_E_CONFIGFORMATINVALID DTS_E_CONFIGFORMATINVALID_PACKAGEDELIMITER ...
Specifies the number of minutes to wait for the drain operation before the port rule is disabled. After the time expires, the existing connections will be dropped. Type:UInt32 Aliases:T Position:Named Default value:None Required:False Accept pipeline input:False ...
If multiple interfaces change from up to down, cards of the local device or peer device may become faulty and the peer device status may change. For example, an active/standby switchover is performed on the peer device, the peer device is in sleeping state or restarted. If a single interf...
If a router or firewall is SIP Aware, that is the SIP Application Layer Gateway (ALG) or similar is enabled, we recommend that you turn off this functionality to maintain correct operation of service. Check the relevant manufacturer's documentation for steps to disable SIP ALG on specific dev...