Lower glass transition temperature, but with lower volumetric density, less prone to warping on a Sun Foaming during travel moves means more stringing, however, easily removable Great for LW Planes or weight reduction of any model PolyLight 1.0 is recommended especially for our LW Planes models des...
The volumetric productivity and product yield, respectively, were calculated at maximum P(3HB) concentration (P(3HB)max [g L−1]). P(3HB)max was calculated from the P(3HB) content [g (100 g CDW)−1], determined by GC analysis from harvested biomass at the end of fermentation and...
After passing through the single-screw extruder, they were injected through holes with a diameter of 1.2 mm by a volumetric pump rotating at 16 rpm to ensure a constant flow. Two bundles of 40 monofilaments were obtained which were then cooled in air and combined into a multifilament. The ...
Irrespective of the nozzle used, the layer thickness chosen, and the type of printer, all the samples were printed with a constant linear speed of 25 mm/s, which obviously caused a wide variation in volumetric speed, which in turn is calculated as the volume of plastic extruded through the...
In the case of calculations made for polylactide, the volumetric elasticity coefficient is negative. It is related to the shifting of the crystal elements under the influence of pressure. Such a phenomenon can also be seen for the alteration of chemical bonds [26]. During the measurements of Po...