the device is a simple box with a lid with laser cut hinges. There are two main layers of the device: the electronics bed and the main bed, with holes for wires to run between the two layers.
These tools (located in the bottom center of the window) are used to view your model in different orientations. With these tools, you can rotate, pan, or zoom in on your file, and even set the viewing angle normal to a specific face or plane. With these tools, you can focus your w...
This Instructables takes a very linear approach to the design process which is one of the caveats of writing an article formed of steps. In reality the design process is much more cyclic and involves no end of iteration and repetition of the steps below. What you see here is the design th...
On many 3D printers, holes are never going to be as precise as they would be if you drilled or reamed them out. This is because the shrinking of the parts alters the size of the part slightly, and also because usually a cartesian-based printer is being used to make a circular hole. ...