The firewall configuration can be reset back to defaults, a process which also attempts to remove any installed packages. This reset can be performed in the GUI from Diagnostics > Factory Defaults, by using the console menu, or in some cases by using a hardware button....
You've got a babysit Snort and Suricata to the point where sometimes you turn it off. " What is our primary use case? I use it for my firewall at home and when virtualizing labs to do routing between different network segments. I use it in the business that I am currently with at ...
What I’ll do is fire up the Ubuntu 24.04 VM and run iperf3 tests from the Ubuntu server to the pfSense client (the other way around does not work with the default firewall configuration), in what should be the worst case scenario: pfSense to Ubuntu [2.7.2-RELEASE][admin@R2-Max-CN...
Firewall/NAT configuration Navigate to System > Advanced > Firewall/NAT Firewall Advanced ·Firewall Optimisation options: conservative. Tries to avoiding legitimate idle connections at expense of memory and CPU utilisation, you can also choose "normal", others are not recommended. ·Firewall Maximum...
I'm starting my home lab and would like to have a pfsense firewall. I'm debating between using a dedicated Optiplex-like (i5 or so) hardware or running it as a VM allocating a couple of cores and say 4GB of ram from my server. While I understand the basics, I don't have much ...
In our review, we are going to take a look at the new router and firewall appliance to see what it has to offer, and how it performs. Netgate SG-2100 Overview This solution is designed to be a low-power and quiet edge device. As a result, Netgate is using a desktop form factor....
echo '#turn off QSS LED' >> /tmp/openvpncl/openvpn-down.sh echo '/sbin/gpio disable 5' >> /tmp/openvpncl/openvpn-down.sh chmod ugo+x /tmp/openvpncl/openvpn-up.sh chmod ugo+x /tmp/openvpncl/openvpn-down.sh Firewall script: #Invoke openvpn fix /tmp/etc/fixovpn.sh...
Note: This will turn off NAT! Or - Create pass any any any rules at firewall/rules, lan and wan tab - enable "advanced outbound nat" at firewall/nat, outbound tab and delete the autocreated rule at the bottom - save and apply ...
Think I tried that but I'll try again tomorrow. > CARP works fine, people don't use it with PPPoE because you can't, at > least not in the usual sense of having a failover firewall. PPPoE's > dynamic interfaces and CARP may not play well together. If you didn't ...
Here is the picture of this option I had to turn on manually. After sorting out these two problems, I was able to ping the FIBRE1 IP (i.e. firewall end of transit network). But I was still not able to ping internet addresses - despite having the FIBRE1 IP set as the DNS server...