but just not sticking to sheet well (already line printed outside print are when print starts, it gets off very easy when just touched by nail). I tried to clean PEI with soap and water, than cleaned it with IPA - same problem. I turned sheet around...
You must have a level bed so you get a well sticking first layer before you will get a reliably good print. Second item. PETG does NOT like to be squished. Your first layer should be .3mm, not .1. Your flow of 110% on the first layer will get the "squish" down. 30% infill...
Bambu PETG-CF is a carbon fiber reinforced PETG that offers improved performance and appearance compared to traditional PETG. The specially formulated blend minimizes the risk of warping and nozzle sticking, while still providing a smooth and consistent
This results in prints with high structural integrity and fewer failures due to layers not sticking together. Another important property of PETG is its transparency.[5] While not completely clear, PETG is more transparent than most other 3D printing materials, making it a good choice for prints ...
I am stuck and don't know what I should be trying next. Any help would be appreciated! I am assuming that it's isolated to Y-Axis problem, because the layers are shifting to the left (layers sticking out in the last picture). Best Answer by Hello: c...
3D printing on its own is not toxic to be very precise. In case you’re using any filaments or any tools they have a tendency to emit harmful fumes or radiations. It can be alarming as it is a risk to your health. Harmful fumes usually originate from certain thermoplastic and plastic ...