NQA的Path Jitter测试先通过trace到目的端,得到从源端到目的端逐跳的IP地址,然后会从源端向每跳IP地址发起ICMP Jitter测试,从而得到路径上逐跳的抖动值。如图7-15所示,探测过程如下: SwitchA向SwitchC发起trace测试,得到路径上每跳的IP地址。 SwitchA向得到的每跳的IP地址发起ICMP Jitter测试,分别得到逐跳的抖动值...
采用如下思路进行Path Jitter测试的配置: SwitchA作为NQA客户端,在SwitchA上配置Path Jitter测试例。 SwitchC作为NQA服务器端。 操作步骤 配置各接口的IP地址并配置交换机之间路由可达 # 配置SwitchA。 <HUAWEI> system-view [HUAWEI] sysname SwitchA [SwitchA] vlan 100 [SwitchA-vlan100] quit [SwitchA] in...
first and second paths, the jitter difference identifying a maximum jitter encountered in an average difference of latency between the first and second paths; and causing at least one of the elimination node or an upstream node along one of the first or second paths to absorb the jitter ...
The jitter values obtained using IP SLAs - ICMP Path Jitter are approximates because ICMP does not provide the capability to embed processing times on devices in the packet. If the target device does not place ICMP packets as the highest priority, then the device will not respond...
The jitter values obtained using IP SLAs - ICMP Path Jitter are approximates because ICMP does not provide the capability to embed processing times on devices in the packet. If the target device does not place ICMP packets as the highest priority, then the device will not re...
a这几个产品已经在哪几个国家上市? These products already in which how many national going on the market?[translate] aA FIFO in the data path accommodates any jitter differences between the serial data and the CMU line-rate clock. 正在翻译,请等待...[translate]...
first and second paths, the jitter difference identifying a maximum jitter encountered in an average difference of latency between the first and second paths; and causing at least one of the elimination node or an upstream node along one of the first or second paths to absorb the jitter ...
High-Speed Signal Link Path and Jitter : Models and Analysis High-Speed Signal Link Path and Jitter : Models and AnalysisFan, Jun
a deteriorated transmission signal and to enable signal transmission for a long distance by obtaining a jitter from a difference between a time between level change point detection pulses for an input transmission signal of a field path and its ideal value, correcting the jitter and outputting it....
To generate the alpha buffer, jittered versions of the rendered path are rendered and corresponding stencil buffers indicating sub-pixel samples of the path that should be covered are generated. After each stencil buffer is generated, the jittered path is rasterized to convert the sub-pixel ...