Using this command, you can create additional instances of the previously created wire and edit its properties. The following prompts are displayed. Select baseline object Specify the baseline pipe. Select parallel pipes Specify the parallel conduit segment. Next point Specify next points in the...
Tip: You can also enter ParallelRouting at the command line. Select the baseline conduit. Tip: Routing begins at the open end of the baseline conduit segment. If the segment is open at both ends, click near the end where you want the routing to begin. Select the parallel conduit se...
By using the parallel or offset command, I can make the parallel lines but the angle of rise of the lines cannot be altered. Is there a way where this can be changed? parallel lines need to touch the line below. \Pls give solution if possible. Thanks Gazaal Reply Report Tags ...
The shape on the left is what the current DLINE command does; allows for the drawing of two parallel lines at one time with a specified width in between. I'd like it to be able to hatch after it does this, as is shown in the image on the right (which I added hatch to my...
在AutoCAD的下拉式菜单“Draw”中选中“Text”,再单击“Multiline Text…”选项,在Command提示区提示用户确定所标注文本的宽度、高度和字体排列方式,系统根据输入信息,确定文本框大小,并弹出一个专门用于文字编辑的文本编辑器,即弹出“Multiline Text Editor”对话框,在选定字型、字高、文本宽度等前提条件后,可直接在...
I reposition the origin so that new origin is shown in red arrow colour in the attached document. First coordinate is (4.5, 6.75) and second coordinate is (2.75, 6.75). That means line should be parallel to X axis that is border line of the Asheet shown in green colour. But it...