在Packet Tracer中配置安全密码和SSH服务,可以按照以下步骤进行: 1. 打开Packet Tracer并创建网络拓扑 首先,打开Packet Tracer软件,并创建一个包含至少一个路由器或交换机的网络拓扑。确保设备之间通过适当的线缆连接,并且已分配好IP地址。 2. 设置IP地址和其他基本网络参数 在需要配置的设备上,通过Packet Tracer的图形...
1.配置pc终端和路由器设备之间的连接，使用Cisco Packet Tracer中的终端测试到路由器的连接。2.在路由器上配置域名，主机名，创建本地登录账号，配置SSH。3.点击pc终端的Telnet/S Client软件。4.输入路由器的ip地址和用户名，点击连接，连接后会要求输入密码。
Solved: I have been having issues with 1.3.6 Configuring SSH. When I complete it, it says the username has an issue, but I have done it the way I have always known to do it. I have watched others do it online as well the same way and its completed.
So, let’s startSSH Configurationand see how is the backplane config of our SSH connection on routers. You can visitCisco Hands On Course with Packet Tracer IP Configurations Beforeconfiguring SSH, firstly, we will configure IP addresses of router interface and the PC. We will use the below ...
环境:Cisco Packet Tracer 5.3 设备:1 台普通 PC,1 台 2950T-24 交换机,2 台 2811 路由器。 拓扑:如下图。 4. 操作步骤 步骤1:按拓扑图添加设备与连接。 步骤2:配置路由器接口。 打开路由器的 Config配置页面,按拓扑图上的标注分别配置两个路由 ...
ssh Open a secure shell client connection telnet Open a telnet connection terminal Set terminal line parameters traceroute Trace route to destination undebug Disable debugging functions (see also 'debug')vlan Configure VLAN parameters write Write running configuration to memory, network, or terminal # ...
ssh Open a secure shell client connection--More-- more表示由于屏幕大小原因,还有部分内容没有显示出来: 回车键:一次向下显示一行 空格键:一次向下显示一屏 特权用户模式转为全局配置模式: 代码语言:javascript 复制 Switch#configure terminal Enter configuration commands,one per line.EndwithCNTL/Z.Switch(config...
1.在Cisco Packet Tracer里交换机的初始配置 基本拓扑图; 点进交换机,会先进入交换机的用户模式,这个模式下交换机的名称后方会以‘>’显示 输入enable会进入交换机的特权模式,同样在交换机的名称后方以‘#’显示 在特权模式的环境下输入configure terminal会进入交换机的全局配置模式...
When working with switches under PT, there is no difference into cyrptographic IOS (k9 images) and non cryptographic IOS: in any case you can activate SSH and create RSA keys. Should be corrected in the next Packet Tracer release.
ssh Open a secure shell client connection telnet Open a telnet connection terminal Set terminal line parameters traceroute Trace route to destination undebug Disable debugging functions (see also 'debug') vlan Configure VLAN parameters write Write running configuration to memory, network, or terminal ...