例句 释义: 全部,面外荷重,平面外加载 更多例句筛选 1. Design of steel structures - Part 1-7: General rules - Supplementary rules for planar plated structural elements with out of plane loading 钢结构设计第1-7部分:一般规则关于无平面载荷的平面电镀构件的补充规则 www.mapeng.net©...
3) in-plane loading 平面内荷载 1. Finite element model for brick masonry wall reinforced with FRP under in-plane loading FRP增强砖砌体墙在平面内荷载作用下有限元模型 更多例句>> 4) out-of-plane loading 平面外加载 1. The result of out-of-plane loading tests shows that the ductility of...
The experimental tests reveals that the commonly observed soft initial non-linear response during out-of-plane compression is a structural effect that stems from the surface roughness rather than being an inherent material behavior. A gluing procedure, used to perform cyclic out-of...
out-of-plane loadinginclined stratabimaterialAnalytical closed-form solutions are proposed in a rather compact form for the stress and displacement fields induced by out-of-plane loading of a semi-infinite anisotropic material with inclined strata. The solutions are then extended to include the case...
In-plane response showed a maximum lateral load of 359 kN at 1.5% drift, with a residual capacity of more than 75% at 4% drift. The subsequent out-of-plane test was performed up to failure with a maximum lateral load of 67 kN, corresponding to about 7 times the infill self-weight....
Using a 3D distinct-element mechanical modeling program, we examined the nature and magnitude of out-of-plane motion during along-strike propagation of a s... J Suppe - 《Journal of Structural Geology》 被引量: 103发表: 2002年 An improved Reynolds-equation model for gas damping of microbeam...
FRCM strengthening of clay brick walls for out of plane loadsdoi:10.1016/j.compositesb.2019.107050Out of plane loadsFE modelMasonry wallsClay brickRepairStrengtheningThe present work deals with the analysis of unreinforced and FRCM reinforced masonry walls subjected to out-of-plane loading. In ...
This paper presents a rational approach for the design and analysis of FRP-strengthened infill-masonry walls subjected to out-of-plane loading, including the effect of using FRP end anchorage. The approach is based on consideration of four potential mechanisms: arching, shear sliding, debonding of...
The results of the tests performed under in-plane shear loading reveal a high load-bearing capacity of both configurations and show that failure is initiated within the adhesive joints. The numerical models, which include previously derived non-linear material models for the adhesives, allow a good...
Seismic loadingOut-of-plane behaviourReinforced renderCFRPThis paper presents part of the results of an experimental campaign for the development of a strengthening technique, aimed at retrofitting old buildings by the application of exterior reinforcing......