If 2-way is displayed, the ospf dr-priority 0 command has been configured on the OSPF interface. In this case, run the ospf dr-priority command to set the DR priority of the interface to a value greater than 0 to clear the alarm. If Exstart is displayed in the command output, the ...
If the neighbor changes from a higher status to a lower status, services may be interrupted. Possible Causes 1. The status of the interface of the virtual link changed. 2. The configured parameters (such as the Hello timer, dead timer, interface authentication, and network type) of the ...
neighbor ipv6-link-local-address [ priority number ] [ poll-interval seconds ][ cost number ] [ database-filter [ all ]] Example: RP/0/RP0/CPU0:router(config-ospf-ar-if)# neighbor 10.20.20.1 priority 3 poll-interval 15 or RP/0/RP0/CPU0:router(config-ospf-ar-...
neighbor ip-address [cost number] [priority number] [poll-interval seconds] no neighbor ip-address [cost number] [priority number] [poll-interval seconds] Syntax Description ip-address Interface IP address of the neighbor. cost number (Optional) Assigns a c...
The following command example sets the hello interval to 5 seconds, the dead interval to 60 seconds, and the priority to 5 for swp51. The hello interval and dead interval can be any value between 1 and 65535 seconds. The priority can be any value between 0 to 255 (0 configu...
The priority can be any value between 0 to 255 (0 configures the interface to never become the OSPF Designated Router (DR) on a broadcast interface). NCLU Commands cumulus@switch:~$ net add interface swp51 ospf6 hello-interval 5 cumulus@switch:~$ net add interface swp51 ospf6 ...
Routers in a broadcast or NBMA network elect the DR and BDR by router priority and ID. Routers with a router priority value higher than 0 are candidates for DR and BDR election. The election votes are hello packets. Each router sends the DR elected by itself in a hello packet to all th...
If the network type is broadcast or NBMA, at least one interface must have a DR priority higher than 0. III. Processing steps 1) Display OSPF neighbor information using the display ospf peer command. 2) Display OSPF interface information using the display ospf interface command. 3) Ping the...
Router_Priority=1; Sample RIP_INTERFACE: RIP_INTERFACE IP_Address=9.29.107.3 Name=TR2 Subnet_mask=255.255.255.0 RIPV2=Yes; Sample INTERFACE: INTERFACE IP_Address=9.77.14.49 Name=ETHB00 Subnet_mask=255.255.255.0; If OMPROUTE is to communicate with the OSPF or RIP Version 2 protocol over a to...
priority-queue out mls qos trust dscp spanning-tree portfast router ospf 1 router-id 2.2.2.2 passive-interface default no passive-interface Vlan60 network 10.2.0.0 0.0.255.255 area 0 network 192.168.40.102 0.0.0.0 area 0 sh interface sh int vlan 60Vlan60 is up, line protocol is up Hardware...